Commercial vs residential property in Australia. When to pivot.

Cap rates, WALE, lease terms, LVR, tenant covenant. The decision framework for when commercial makes sense in an Australian portfolio, and the specific stage where the pivot usually pays off.

JT
By James Thompson, Licensed Buyers Agent · Published 4 July 2026 · 12 min read

The short answer. Commercial property usually enters the mix at Stage 3 Balance, when residential lending capacity has been exhausted and yield becomes the constraint. Below that stage, commercial has a place but requires deliberate reasons. Above it, commercial is often the difference between a portfolio that stalls and one that keeps compounding.

The five differences that matter

Every difference between commercial and residential in Australia flows from one root distinction: who pays the outgoings. In residential, the landlord pays council, water, insurance, land tax, and maintenance. In most commercial leases, the tenant pays them via a net lease.

That single structural difference cascades into the five things you actually feel:

MetricResidentialCommercial
Gross yield4.0-4.5% typical5.5-8.5% depending on sector
Net yield~2.5-3.0% after costs~5.5-8.0% on net lease
Vacancy riskLow, 2-4% typicalHigher, sector-dependent 3-8%
Lease term12 months typical3-10 years with options
LVR available80%, sometimes 90%65-70% typical
Interest rate6.5% typical7.0-7.5% typical
Capital growth3-7% p.a. long run3-5% p.a., income-driven
Cash flowUsually negative Y1Usually positive Y1
Serviceability impactFull loan on serviceabilitySelf-servicing on cash flow

The trade-off in one sentence

Residential trades cash flow drag for capital growth. Commercial trades capital growth for cash flow. Both compound over time. The right mix depends on what stage you are on and what your goal actually is.

Cap rate is the number that matters

In residential, you look at gross yield. In commercial, you look at cap rate. They sound similar. They are not the same.

Cap rate = net operating income / property price. Net operating income is rent minus outgoings that the landlord actually pays. On a net lease where the tenant pays everything, cap rate = rent divided by price. On a gross lease where the landlord pays, it is rent minus outgoings divided by price.

Cap rate is what the market pays for the income stream. Higher cap rate means the market discounts the income (more risk perceived, more compensation demanded). Lower cap rate means the market has bid up the property (perceived safer, willing to accept lower yield).

Cap rate ranges by sector

SectorCap rate rangeWhy
Prime CBD office5.5-6.5%Institutional buyers, long leases, low volatility
Suburban office6.5-8.0%Wider tenant pool, more competition
Retail (main street)5.5-7.0%Foot traffic, tenant mix matters
Retail (strip / neighbourhood)6.0-8.5%Tenant covenant varies wildly
Industrial (metro)5.0-6.5%Post-pandemic tightening, logistics demand
Industrial (regional)6.5-9.0%Smaller pool, longer sale periods
Medical / healthcare5.5-7.0%Long leases, sticky tenants, growing demand

WALE and why it is the second-most-important number

WALE is Weighted Average Lease Expiry. It tells you, weighted by rent, how many years until your tenants' leases expire.

A single-tenant property with a 7-year lease has a WALE of 7. A three-tenant property where tenant A (60% of rent) has 3 years left, tenant B (30%) has 5 years, and tenant C (10%) has 2 years, has a WALE of 3.5.

Why it matters: short WALE means near-term re-leasing risk, which means near-term vacancy risk, which means the bank wants a bigger buffer and the market discounts the property. Long WALE means predictable income for years, which means banks and the market pay up.

The tracker treatment. StratMap models WALE-driven vacancy uplift automatically. Baseline vacancy = sector default. Uplift stacks on top: 5+ years WALE adds nothing, 3-5 years adds 2 percentage points, 2-3 years adds 4 pp, under 2 years adds 6 pp. This is why the same property with the same rent can have very different modelled cash flow depending on lease terms.

The Stage 3 pivot

Most Australian investors reach a point at 3-4 residential properties where the bank says no. Serviceability calculations use notional rates (usually 3% higher than actual) and stress-test income against liabilities. At 4 residential properties, you typically hit the wall regardless of your income.

At this point, three options exist:

  1. Wait. 18-24 months while incomes rise, LVRs fall, and capacity rebuilds. Passive but slow.
  2. Pay down. Aggressive P&I on the highest-rate loan to shrink liabilities. Works, but slow.
  3. Commercial pivot. Buy a commercial property that services itself. Doesn't consume residential capacity.

Why commercial is often the answer

A commercial property with a positive cash flow lease services itself on paper. Banks assess the loan against the property's own income, not primarily against your personal serviceability. This means it doesn't eat into your future residential capacity the way a fifth residential property would.

Real numbers, roughly typical:

Watch-out: LVR and rate premiums are real. 70% LVR means bigger deposit. 7.5% rate means higher borrowing cost. On top of that, commercial DD is harder (tenant covenant checks, lease review, WALE analysis, site inspection with commercial nuance). This is a Stage 3 move because by then you have the deposit, the income, and the appetite to learn a new asset class. It is a poor Stage 1 move unless you have specific commercial expertise.

Common commercial mistakes

Chasing yield without covenant

A 9% cap rate on a suburban office looks amazing until you discover the tenant is a two-year-old startup with 4 employees and 8 months of runway. High cap rate is the market pricing in risk. Sometimes the risk is real.

Ignoring lease review mechanics

Commercial leases have review clauses: fixed % annual escalation (usually CPI or a set %), market review (rent reset to market at option renewal), or ratchet (up-only) versus non-ratchet. A fixed 4% annual escalation is worth substantially more over a 10-year lease than a market-review clause where rent could go up, down, or nowhere.

Underestimating tenant fitout costs

When a commercial tenant leaves, the property may need substantial refurbishment before re-leasing. Painting, partition changes, aircon service, sometimes complete refit for the incoming tenant. Budget an "incentive" line for retail and office assets. Industrial is usually simpler.

Buying regional when you have no regional network

A high-cap-rate regional industrial building looks great on paper. When the tenant vacates in year 4 and you need to re-lease, you discover you have no property manager relationships, no local business network, no idea what the actual market rent is. Regional commercial rewards local knowledge.

When commercial does NOT make sense

The framework applied

Model both, side by side, in the tracker:

  1. Scenario A: Continue residential. Property 5 at $750k residential. Cash flow, growth, serviceability impact.
  2. Scenario B: Commercial pivot. Property 5 at $650k retail with 7% cap. Cash flow, growth, serviceability impact.

Look at the two 10-year projections next to each other. Which one lands closer to your goal? Which one preserves optionality for property 6 and 7?

That is the framework. Not a rule, a comparison.

The compliance frame. Commercial property is not a financial product under the Corporations Act 2001. StratMap does not hold an AFSL. This article is educational. Commercial DD, tenant covenant assessment, and structural decisions should involve a licensed commercial buyers agent, a specialist commercial solicitor, and your accountant. The tracker models. Your professional team advises.

Model both scenarios side by side.

Open the free tracker. Add a residential and a commercial candidate. See the 10-year projection under each.

Open the tracker free